If your Ikea refrigerator water dispenser is not working, start with the parts that fail most often: the dispenser actuator, which physically pushes the switch to send power to the dispenser; a frozen water tube in the door, which you can check by disconnecting the tube and blowing air through it; and a faulty water inlet valve or low house water pressure that prevents the valve from opening (the inlet needs about 20 psi and you can test the valve for continuity with a multimeter). After those, make sure the water filter is seated correctly or replaced if old, and confirm the refrigerator’s supply valve at the wall is fully open. Whether your fridge water dispenser is not dispensing at all or the fridge water dispenser not working intermittently, these checks usually pinpoint the problem. If you find a bad actuator, inlet valve, filter or other part, enter your model number on RepairClinic.com to pull up the exact replacement part and repair instructions specific to your refrigerator.
01 - Ikea Refrigerator Dispenser Actuator
The dispenser actuator is the component that activates the switch or switches to send voltage to the dispenser. If the dispenser actuator is damaged, it may be unable to activate the switch. Inspect the dispenser actuator for any damage and replace with a new one if necessary.
Enter model number to search for the required part specific to your product
To determine if the water supply tube is frozen, disconnect the tube at the bottom of the door and blow air through it. If air does not pass through, this indicates that the water supply tube is frozen. If the water supply tube is frozen, thaw it out. In addition, ensure that the freezer is kept at the proper temperature. The freezer temperature should be kept from 0 to10 degrees Fahrenheit (-18 to -12 degrees Celsius). If the freezer is too cold, the water line may freeze.
Top Solution
03 - Ikea Refrigerator Water Inlet Valve
The water inlet valve opens to supply water to the dispenser. If the water inlet valve is defective, or if the water pressure is too low, the water valve will not open. The valve requires at least 20psi to function properly. Make sure that the water pressure to the valve is at least 20 psi. If the water pressure is sufficient, use a multimeter to test the water inlet valve for continuity. If the water inlet valve does not have continuity, replace it.
The home may have insufficient water pressure. The water inlet valve requires strong water pressure to supply water to the water dispenser. You can check the water flow at the kitchen faucet to help determine if the home's water pressure is sufficient or not.
Highly Likely
05 - Misaligned water filter
Water filter may not be seated properly. Remove and reinstall the water filter. For optimal performance, refrigerator water filters should be replaced every six months or after 200-300 gallons (760-1150 liters) of water have been dispensed - whichever comes first. Replace the water filter if needed.
Highly Likely
06 - Home's water supply valve not fully open
The refrigerator is connected to a water supply valve that may not be fully open. If the water line was disconnected or the valve was shut off for service, it may not have been turned back on to the fully opened position.
Highly Likely
Frequently Asked Questions
Why is my refrigerator water dispenser not working?
How can I tell if the water tube in the door is frozen?
How do I test the water inlet valve on my fridge?
The dispenser button doesn't activate water. Could the dispenser actuator be bad?
How do I enter my model or part number on RepairClinic to buy the correct replacement?