Choose Product
Identify Problem
03
Find Solutions

Montgomery Wards Refrigerator freezer not freezing

If your freezer is not freezing, start with the evaporator fan motor—that’s the most likely culprit because it moves cold air over the evaporator coils; try spinning the fan blade by hand, listen for unusual noise, and test the motor windings with a multimeter, replacing the motor if it binds, is noisy, or shows no continuity. If the fan checks out, inspect the freezer door gasket for tears, gaps, or warping that let warm air in and prevent proper cooling. A faulty condenser fan motor is another common cause, so clear any obstructions, spin the condenser fan blade, and test for continuity. Control board failures are possible but often misdiagnosed, so only swap the control board after ruling out fans, gasket problems, and controls. Also check the temperature control thermostat for a click and continuity, and test the start relay if the compressor will not run or you notice a burnt odor. Whether you need an evaporator fan motor, gasket, condenser fan, thermostat, or start relay for freezer not freezing repair, enter your model number on RepairClinic.com to find the exact replacement part for your refrigerator.

01 - Montgomery Wards Refrigerator Evaporator Fan Motor

The evaporator fan motor draws air over the evaporator (cooling) coils and circulates it throughout the refrigerator and freezer compartments. Some refrigerators have more than one evaporator fan motor. On refrigerators with two evaporators, there will be an evaporator located in both the freezer and refrigerator compartments. If the evaporator fan is not working, it will not circulate the cold air in the compartment. If this occurs, the refrigerator may still get cold, while the freezer will not get cold or vice versa. To determine if the evaporator fan motor is defective, try turning the fan blade by hand. If the fan bla...de does not turn freely, replace the fan motor. Additionally, if the motor is unusually noisy, replace it. Finally, if the motor does not run at all, use a multimeter to test the motor windings for continuity. If the windings do not have continuity, replace the evaporator fan motor.
Enter model number to search for the required part specific to your product
Top Solution

02 - Montgomery Wards Refrigerator Door Gasket

A freezer door gasket should form an airtight seal around the appliance's frame to keep the cold air in and the warm air out. If the door gasket is twisted or torn, gaps can form that will allow warm air in, resulting in the freezer not freezing properly. Inspect the door gasket for any damage and replace with a new one if necessary.
Highly Likely

03 - Montgomery Wards Refrigerator Condenser Fan Motor

The condenser fan motor draws air though the condenser coils and over the compressor. If the condenser fan motor is not working properly, the refrigerator won’t cool properly. To determine if the fan motor is defective, first check the fan blade for obstructions. Next, try turning the fan motor blade by hand. If the blade does not spin freely, replace the condenser fan motor. If no obstructions are present and the fan blade spins freely, use a multimeter to test the fan motor for continuity. If the condenser fan motor does not have continuity, replace it.
Common

04 - Montgomery Wards Refrigerator Control Board

Control boards are often misdiagnosed—before replacing the control board, first check more commonly defective parts. If you have determined that all of the other components are working properly, replace the control board.
Common

05 - Montgomery Wards Refrigerator Temperature Control Thermostat

The temperature control thermostat directs voltage to the compressor, evaporator fan motor, and condenser fan motor (if applicable). If the temperature control thermostat is not working properly, it may prevent the freezer's refrigerant system from running. To determine if the thermostat is defective, rotate the thermostat from the lowest setting to the highest setting and listen for a click. If the thermostat clicks, it is not likely defective. If the thermostat does not click, use a multimeter to test the thermostat for continuity. If the temperature control thermostat does not have continuity at any setting, replace it.
Common

06 - Montgomery Wards Refrigerator Start Relay

The start relay works in conjunction with the start winding to start the compressor. If the start relay is defective, the compressor may sometimes fail to run or may not run at all. As a result, the freezer will not be able to freeze properly. To determine if the start relay is defective, use a multimeter to test it for continuity between the run and start terminal sockets. If the start relay does not have continuity between the run and start terminal sockets, replace it. In addition, if the start relay has a burnt odor, replace it.
Common

Frequently Asked Questions

Freezer not freezing but refrigerator seems cold — what causes this?
Fridge not cooling but freezer works — where should I start troubleshooting?
How do I test the evaporator or condenser fan motor?
Should I replace the control board if my refrigerator is not defrosting or not cooling?
How do I enter my model number or part number to find the right replacement part on RepairClinic.com?

Shop by Montgomery Wards Refrigerator Parts