Amana Refrigerator ice and water dispenser not working
If your Amana ice and water dispenser is not working, start by checking the dispenser actuator because a broken actuator often can no longer engage the switch to send power to the dispenser. Next suspect the dispenser control board when the whole dispenser system is dead, but only after you test individual components. Then check the dispenser switches themselves with a multimeter for continuity, followed by the door switch which must close to enable dispensing. Make sure doors, drawers and ice buckets are fully seated since a door not closing properly can prevent the dispenser from operating. Finally inspect the water filter housing and its seating if water will not flow. Whether the problem is a water dispenser not working, ice dispenser not working, or the refrigerator dispenser not dispensing water at all, these checks will narrow the fault so you can replace the right component. Enter your model number on RepairClinic.com to find the exact replacement dispenser actuator, control board, switch, door switch, or filter housing that fits your fridge.
01 - Amana Refrigerator Dispenser Actuator
The dispenser actuator is the component that activates the switch or switches to send voltage to the dispenser. If the dispenser actuator is damaged, it may be unable to activate the switch. Inspect the dispenser actuator for any damage and replace with a new one if necessary.
Enter model number to search for the required part specific to your product
The dispenser control board governs most of the functions of the dispenser system. If only one dispenser part is not working, it is probable that an individual part has failed. In this case, test each of the dispenser components before testing the control board. If the entire dispenser system is not working, the control board is more likely to be at fault.
The dispenser switches send voltage to the dispenser. If one of the dispenser switches is defective, the dispenser will not work. To determine if a dispenser switch is defective, use a multimeter to test each switch for continuity. If a dispenser switch does not have continuity, replace it.
The door switch turns off the ice and water dispenser when the refrigerator door is open. If the door switch fails, the dispenser will not turn on. To determine if the door switch is defective, use a multimeter to test it for continuity. If the door switch does not have continuity when activated, replace it.
Check to make sure all drawers and ice buckets are pushed in properly. Be sure the refrigerator doors are completely closed. There should be no visible gap around the door gasket.
Highly Likely
06 - Amana Refrigerator Water Filter Housing
On many refrigerators, the incoming water will pass through a water filter before reaching the dispenser or the ice maker fill tube. If the water filter housing is damaged, water may not flow through the housing when the filter is installed. Inspect the water filter housing for damage and confirm it is properly seated. If necessary replace the damaged housing with a new one.