Goldstar Refrigerator ice and water dispenser not working
If your refrigerator water dispenser not working or the ice dispenser not working, start with the dispenser actuator — it physically trips the switches and often fails first. If the whole dispenser system is dead after checking the actuator, the dispenser control board is the next likely culprit, but test individual components first before replacing the board. Faulty dispenser switches are common and easy to confirm with a multimeter for continuity; the door switch can also prevent dispensing if it fails. Sometimes the problem is simple: drawers, ice buckets, or doors not closing properly can keep the dispenser disabled. A damaged or improperly seated water filter housing will block flow and make the refrigerator dispenser not dispense water. Work top to bottom: inspect the actuator, test switches, verify door closure, then check the housing and control board. Enter your model number at RepairClinic.com to find the exact replacement actuator, switch, control board, or water filter housing that fits your refrigerator and get step-by-step parts instructions.
01 - Goldstar Refrigerator Dispenser Actuator
The dispenser actuator is the component that activates the switch or switches to send voltage to the dispenser. If the dispenser actuator is damaged, it may be unable to activate the switch. Inspect the dispenser actuator for any damage and replace with a new one if necessary.
Enter model number to search for the required part specific to your product
02 - Goldstar Refrigerator Dispenser Control Board
The dispenser control board governs most of the functions of the dispenser system. If only one dispenser part is not working, it is probable that an individual part has failed. In this case, test each of the dispenser components before testing the control board. If the entire dispenser system is not working, the control board is more likely to be at fault.
The dispenser switches send voltage to the dispenser. If one of the dispenser switches is defective, the dispenser will not work. To determine if a dispenser switch is defective, use a multimeter to test each switch for continuity. If a dispenser switch does not have continuity, replace it.
The door switch turns off the ice and water dispenser when the refrigerator door is open. If the door switch fails, the dispenser will not turn on. To determine if the door switch is defective, use a multimeter to test it for continuity. If the door switch does not have continuity when activated, replace it.
Check to make sure all drawers and ice buckets are pushed in properly. Be sure the refrigerator doors are completely closed. There should be no visible gap around the door gasket.
Highly Likely
06 - Goldstar Refrigerator Water Filter Housing
On many refrigerators, the incoming water will pass through a water filter before reaching the dispenser or the ice maker fill tube. If the water filter housing is damaged, water may not flow through the housing when the filter is installed. Inspect the water filter housing for damage and confirm it is properly seated. If necessary replace the damaged housing with a new one.