Caloric Refrigerator ice and water dispenser not working
If your Caloric refrigerator ice and water dispenser not working, start with the parts that actually make the dispenser pulse power and open the valve. The dispenser actuator is the most common culprit; if it is cracked or worn it will not trip the dispenser switch to send voltage. If the whole dispenser system is dead, the dispenser control board is the next likely failure, but test individual components first before replacing the board. Dispenser switches themselves can fail, so use a multimeter to check each switch for continuity. Next check the door switch and make sure doors, drawers and ice buckets are fully closed and sealing, since an open or misaligned door will keep the dispenser from operating. Finally inspect the water filter housing for damage or poor seating that can block flow. For parts, enter your refrigerator model number on RepairClinic.com to see the exact replacement actuator, control board, switch, door switch or filter housing that fits your fridge water dispenser not working issue.
01 - Caloric Refrigerator Dispenser Actuator
The dispenser actuator is the component that activates the switch or switches to send voltage to the dispenser. If the dispenser actuator is damaged, it may be unable to activate the switch. Inspect the dispenser actuator for any damage and replace with a new one if necessary.
Enter model number to search for the required part specific to your product
The dispenser control board governs most of the functions of the dispenser system. If only one dispenser part is not working, it is probable that an individual part has failed. In this case, test each of the dispenser components before testing the control board. If the entire dispenser system is not working, the control board is more likely to be at fault.
The dispenser switches send voltage to the dispenser. If one of the dispenser switches is defective, the dispenser will not work. To determine if a dispenser switch is defective, use a multimeter to test each switch for continuity. If a dispenser switch does not have continuity, replace it.
The door switch turns off the ice and water dispenser when the refrigerator door is open. If the door switch fails, the dispenser will not turn on. To determine if the door switch is defective, use a multimeter to test it for continuity. If the door switch does not have continuity when activated, replace it.
Check to make sure all drawers and ice buckets are pushed in properly. Be sure the refrigerator doors are completely closed. There should be no visible gap around the door gasket.
Highly Likely
06 - Caloric Refrigerator Water Filter Housing
On many refrigerators, the incoming water will pass through a water filter before reaching the dispenser or the ice maker fill tube. If the water filter housing is damaged, water may not flow through the housing when the filter is installed. Inspect the water filter housing for damage and confirm it is properly seated. If necessary replace the damaged housing with a new one.