Admiral Washer clothes still wet at the end of cycle
If your Admiral washer leaves clothes soaking wet at the end of the cycle, the inner tub may not be spinning fast enough to remove water. The most likely cause is a worn clutch, which helps spin the basket in many top load washers. Next, inspect the drive belt for damage, looseness, or signs that it is slipping on the pulleys. A worn clutch band kit can cause the same problem on applicable models. If the transmission engages but the basket spins slowly or not at all, inspect the basket drive and hub for worn clutch pads, stripped spin tube tabs, a damaged drive block, or stripped hub teeth. A defective motor control board is another possible cause, especially if it has burned components or fails to send power to the motor. These problems can leave a washing machine not spinning out water even though the cycle appears to finish normally. Enter your Admiral washer's model number to find the exact replacement clutch, belt, clutch band kit, basket drive, hub, or motor control board for your specific machine.
01 - Admiral Washing Machine Clutch
Some top load washers use a clutch to spin the inner tub. If the clutch gets worn the clothes may come out wet.
Enter model number to search for the required part specific to your product
Some top load washers use a clutch to spin the inner tub. If the clutch gets worn the clothes may come out wet. You can fix the problem you can install a new clutch band kit, if applicable to the model.
The basket drive sits on top of the transmission and engages with the inner tub. If the transmission is engaging to spin, and the outer tub spins slowly or does not spin at all, the spin tube tabs may be stripped. Alternatively, the drive block on the spin tube may be stripped. Inspect both the spin tube tabs and the drive block. If the spin tube tabs and drive block are not worn out, the clutch pads on the basket drive are likely worn out. If the clutch pads are worn out, you must replace the basket drive.
The hub is seated on top of the transmission and engages with the inner tub. If the transmission is engaged to spin, and the outer tub spins slowly or does not spin at all, the hub teeth may be stripped. Inspect the hub for damage or wear and replace if necessary.
The motor control board provides power to the motor. If the motor control board is defective, the washer may not function properly or may not work at all. First, check the control board for burned out components. To determine if the motor control board is defective, ensure that the control board is providing power to the motor. If the control board has power, but is not providing power to the motor, replace it.