Jenn Air Washer clothes still wet at the end of cycle
If your Jenn Air washer leaves clothes wet at the end of the cycle, the washer may not be spinning out water fast enough. A worn clutch is the most likely cause on models that use one to spin the inner tub, followed by a broken or loose drive belt. A worn clutch band kit can produce the same symptom. If the washer is not spinning properly, inspect the basket drive for worn clutch pads, stripped spin tube tabs, or a damaged drive block. Next, check the hub for stripped teeth that prevent the inner tub from engaging the transmission. If these mechanical parts are in good condition, the motor control board may not be supplying power to the drive motor. These failures can leave washer clothes soaking wet or cause washing machine clothes still wet at the end of the cycle, even when the wash and drain functions seem normal. Unplug the washer before inspecting moving parts, and replace damaged components as needed. Enter your Jenn Air washer model number to find the exact replacement clutch, drive belt, clutch band kit, basket drive, hub, or motor control board for your specific machine.
01 - Jenn Air Washing Machine Clutch
Some top load washers use a clutch to spin the inner tub. If the clutch gets worn the clothes may come out wet.
Enter model number to search for the required part specific to your product
Some top load washers use a clutch to spin the inner tub. If the clutch gets worn the clothes may come out wet. You can fix the problem you can install a new clutch band kit, if applicable to the model.
The basket drive sits on top of the transmission and engages with the inner tub. If the transmission is engaging to spin, and the outer tub spins slowly or does not spin at all, the spin tube tabs may be stripped. Alternatively, the drive block on the spin tube may be stripped. Inspect both the spin tube tabs and the drive block. If the spin tube tabs and drive block are not worn out, the clutch pads on the basket drive are likely worn out. If the clutch pads are worn out, you must replace the basket drive.
The hub is seated on top of the transmission and engages with the inner tub. If the transmission is engaged to spin, and the outer tub spins slowly or does not spin at all, the hub teeth may be stripped. Inspect the hub for damage or wear and replace if necessary.
The motor control board provides power to the motor. If the motor control board is defective, the washer may not function properly or may not work at all. First, check the control board for burned out components. To determine if the motor control board is defective, ensure that the control board is providing power to the motor. If the control board has power, but is not providing power to the motor, replace it.