Norge Washer clothes still wet at the end of cycle
If your Norge washer leaves clothes still wet at the end of the cycle, the inner tub may not be spinning fast enough to remove water. The most likely cause is a worn clutch, which can prevent the tub from reaching full spin speed. A broken or loose drive belt is another common reason a washing machine leaves clothes soaking wet, so inspect the belt and pulleys for damage or slack. If applicable to your model, a worn clutch band kit can cause the same problem. Next, check the basket drive for worn clutch pads, stripped spin tube tabs, or a damaged drive block. A worn hub can also keep the inner tub from engaging properly, especially when the transmission is spinning but the basket turns slowly or not at all. If these mechanical parts are in good condition, the motor control board may not be supplying power to the motor. These problems can make a washer not spin out water or leave wet clothes after the cycle. Enter your Norge washer model number to find the exact replacement clutch, drive belt, basket drive, hub, or control board for your specific machine.
01 - Norge Washing Machine Clutch
Some top load washers use a clutch to spin the inner tub. If the clutch gets worn the clothes may come out wet.
Enter model number to search for the required part specific to your product
Some top load washers use a clutch to spin the inner tub. If the clutch gets worn the clothes may come out wet. You can fix the problem you can install a new clutch band kit, if applicable to the model.
The basket drive sits on top of the transmission and engages with the inner tub. If the transmission is engaging to spin, and the outer tub spins slowly or does not spin at all, the spin tube tabs may be stripped. Alternatively, the drive block on the spin tube may be stripped. Inspect both the spin tube tabs and the drive block. If the spin tube tabs and drive block are not worn out, the clutch pads on the basket drive are likely worn out. If the clutch pads are worn out, you must replace the basket drive.
The hub is seated on top of the transmission and engages with the inner tub. If the transmission is engaged to spin, and the outer tub spins slowly or does not spin at all, the hub teeth may be stripped. Inspect the hub for damage or wear and replace if necessary.
The motor control board provides power to the motor. If the motor control board is defective, the washer may not function properly or may not work at all. First, check the control board for burned out components. To determine if the motor control board is defective, ensure that the control board is providing power to the motor. If the control board has power, but is not providing power to the motor, replace it.