Choose Product
Identify Problem
03
Find Solutions

Roper Washer clothes still wet at the end of cycle

If your Roper washer leaves clothes soaking wet at the end of the cycle, the washer may not be spinning the water out properly. The most likely cause is a worn clutch, which can prevent the inner tub from reaching spin speed. Next, inspect the drive belt for damage, looseness, or signs that it has slipped off the pulleys. A worn clutch band kit can cause the same problem on applicable top load models. If those parts are in good condition, check the basket drive for worn clutch pads, stripped spin tube tabs, or a damaged drive block. A stripped hub can also keep the inner tub from spinning even when the transmission engages. Finally, test the motor control board, which should send power to the drive motor. These failures can leave a washer not spinning out water and explain why your washer clothes are still wet after the cycle. Enter your Roper washer model number to find the exact replacement clutch, belt, basket drive, hub, or motor control board for your specific machine.

01 - Roper Washing Machine Clutch

Some top load washers use a clutch to spin the inner tub. If the clutch gets worn the clothes may come out wet.
Enter model number to search for the required part specific to your product
Highly Likely

02 - Roper Washing Machine Drive Belt

Inspect the drive belt to determine if it is broken or if it is loose on the pulleys. If the drive belt is broken or loose, replace it.
Highly Likely

03 - Roper Washing Machine Clutch Band Kit

Some top load washers use a clutch to spin the inner tub. If the clutch gets worn the clothes may come out wet. You can fix the problem you can install a new clutch band kit, if applicable to the model.
Common

04 - Roper Washing Machine Basket Drive

The basket drive sits on top of the transmission and engages with the inner tub. If the transmission is engaging to spin, and the outer tub spins slowly or does not spin at all, the spin tube tabs may be stripped. Alternatively, the drive block on the spin tube may be stripped. Inspect both the spin tube tabs and the drive block. If the spin tube tabs and drive block are not worn out, the clutch pads on the basket drive are likely worn out. If the clutch pads are worn out, you must replace the basket drive.
Common

05 - Roper Washing Machine Hub

The hub is seated on top of the transmission and engages with the inner tub. If the transmission is engaged to spin, and the outer tub spins slowly or does not spin at all, the hub teeth may be stripped. Inspect the hub for damage or wear and replace if necessary.
Common

06 - Roper Washing Machine Motor Control Board

The motor control board provides power to the motor. If the motor control board is defective, the washer may not function properly or may not work at all. First, check the control board for burned out components. To determine if the motor control board is defective, ensure that the control board is providing power to the motor. If the control board has power, but is not providing power to the motor, replace it.
Common

Frequently Asked Questions

Why are my Roper washer clothes still wet at the end of the cycle?
What should I check first if my Roper washer is not spinning?
How do I know if the basket drive or hub is causing my washer not to spin?
Could the motor control board cause my Roper washer clothes to stay wet?
How do I find the correct Roper washer part for a spin problem?

Shop by Roper Washing Machine Parts