When your Asko washer leaves clothes soaking wet at the end of the cycle, the inner tub may not be spinning fast enough to remove water. A worn clutch is the most likely cause on models that use one, followed by a broken or loose drive belt. Inspect the clutch and belt first, since either can cause a washer not spinning out water even though the wash cycle completes. If the problem continues, the clutch band kit may be worn and need replacement. A damaged basket drive or stripped spin tube tabs, drive block, or basket drive clutch pads can also prevent the tub from reaching spin speed. Next, inspect the hub for worn or stripped teeth that keep the inner tub from engaging. If these mechanical parts check out, a faulty motor control board may not be supplying power to the motor. These failures can cause a washing machine with clothes still wet to finish a cycle without properly extracting water. Before ordering an Asko replacement part, enter your model number to find the exact clutch, drive belt, basket drive, hub, or motor control board that fits your specific washing machine.
01 - Asko Washing Machine Clutch
Some top load washers use a clutch to spin the inner tub. If the clutch gets worn the clothes may come out wet.
Enter model number to search for the required part specific to your product
Some top load washers use a clutch to spin the inner tub. If the clutch gets worn the clothes may come out wet. You can fix the problem you can install a new clutch band kit, if applicable to the model.
The basket drive sits on top of the transmission and engages with the inner tub. If the transmission is engaging to spin, and the outer tub spins slowly or does not spin at all, the spin tube tabs may be stripped. Alternatively, the drive block on the spin tube may be stripped. Inspect both the spin tube tabs and the drive block. If the spin tube tabs and drive block are not worn out, the clutch pads on the basket drive are likely worn out. If the clutch pads are worn out, you must replace the basket drive.
The hub is seated on top of the transmission and engages with the inner tub. If the transmission is engaged to spin, and the outer tub spins slowly or does not spin at all, the hub teeth may be stripped. Inspect the hub for damage or wear and replace if necessary.
The motor control board provides power to the motor. If the motor control board is defective, the washer may not function properly or may not work at all. First, check the control board for burned out components. To determine if the motor control board is defective, ensure that the control board is providing power to the motor. If the control board has power, but is not providing power to the motor, replace it.