Haier Washer clothes still wet at the end of cycle
When your Haier washer leaves clothes soaking wet at the end of the cycle, the inner tub may not be spinning fast enough to remove water. A worn clutch is the most likely cause, especially in a top load washer, because it engages the spin basket. Next, inspect the drive belt for signs that it is broken, loose, or slipping on the pulleys. If the belt is in good condition, the clutch band kit may be worn and require replacement. Other common causes include a damaged basket drive or stripped drive block and spin tube tabs, followed by a worn hub with damaged teeth that cannot properly engage the inner tub. If these mechanical parts check out, the motor control board may not be sending power to the drive motor. These problems can cause a washer not spinning out water, a washing machine with clothes still wet, or washer clothes wet at the end of the cycle. Unplug the appliance before testing or replacing parts, and enter your model number to find the exact replacement part for your specific Haier washing machine.
01 - Haier Washing Machine Clutch
Some top load washers use a clutch to spin the inner tub. If the clutch gets worn the clothes may come out wet.
Enter model number to search for the required part specific to your product
Some top load washers use a clutch to spin the inner tub. If the clutch gets worn the clothes may come out wet. You can fix the problem you can install a new clutch band kit, if applicable to the model.
The basket drive sits on top of the transmission and engages with the inner tub. If the transmission is engaging to spin, and the outer tub spins slowly or does not spin at all, the spin tube tabs may be stripped. Alternatively, the drive block on the spin tube may be stripped. Inspect both the spin tube tabs and the drive block. If the spin tube tabs and drive block are not worn out, the clutch pads on the basket drive are likely worn out. If the clutch pads are worn out, you must replace the basket drive.
The hub is seated on top of the transmission and engages with the inner tub. If the transmission is engaged to spin, and the outer tub spins slowly or does not spin at all, the hub teeth may be stripped. Inspect the hub for damage or wear and replace if necessary.
The motor control board provides power to the motor. If the motor control board is defective, the washer may not function properly or may not work at all. First, check the control board for burned out components. To determine if the motor control board is defective, ensure that the control board is providing power to the motor. If the control board has power, but is not providing power to the motor, replace it.