If your ARDO washer leaves clothes soaking wet at the end of the cycle, the inner tub may not be reaching the proper spin speed. A worn washing machine clutch is the most likely cause, especially on top load models, because it engages the tub for spinning. Next, inspect the drive belt for damage, looseness, or signs that it has slipped off the pulleys. A worn clutch band kit can cause the same washer not spinning out water symptom when applicable to your model. If those parts are in good condition, check the basket drive for worn clutch pads, stripped spin tube tabs, or a damaged drive block. A worn washer hub can also fail to engage the inner tub, leaving clothes wet at the end of the cycle. If the mechanical parts check out, the motor control board may not be supplying power to the drive motor. These problems can cause a washer with clothes still wet, a washing machine with clothes still wet, or a washer that spins too slowly. Enter your ARDO washer's model number to find the exact replacement clutch, belt, hub, basket drive, or motor control board for your specific machine.
01 - ARDO Washing Machine Clutch
Some top load washers use a clutch to spin the inner tub. If the clutch gets worn the clothes may come out wet.
Enter model number to search for the required part specific to your product
Some top load washers use a clutch to spin the inner tub. If the clutch gets worn the clothes may come out wet. You can fix the problem you can install a new clutch band kit, if applicable to the model.
The basket drive sits on top of the transmission and engages with the inner tub. If the transmission is engaging to spin, and the outer tub spins slowly or does not spin at all, the spin tube tabs may be stripped. Alternatively, the drive block on the spin tube may be stripped. Inspect both the spin tube tabs and the drive block. If the spin tube tabs and drive block are not worn out, the clutch pads on the basket drive are likely worn out. If the clutch pads are worn out, you must replace the basket drive.
The hub is seated on top of the transmission and engages with the inner tub. If the transmission is engaged to spin, and the outer tub spins slowly or does not spin at all, the hub teeth may be stripped. Inspect the hub for damage or wear and replace if necessary.
The motor control board provides power to the motor. If the motor control board is defective, the washer may not function properly or may not work at all. First, check the control board for burned out components. To determine if the motor control board is defective, ensure that the control board is providing power to the motor. If the control board has power, but is not providing power to the motor, replace it.