When your ARDO washer won't agitate or spin, the washer not agitating or spinning may be caused by a failed rotor and stator kit, especially if the machine has a burning smell, wet stator coils, smoking, or shorted coil wires. Test the stator coils with a multimeter and replace the kit if it is damaged. Next, inspect the motor coupling, which connects the drive motor to the transmission and can break from overloading or normal wear. A faulty control board may also stop sending voltage to the motor, but test the lid switch or door switch first and check the board for burned components. Then inspect the drive belt for looseness or breakage. A defective timer is possible but less common, so confirm the other components work before replacing it. Finally, test the lid switch assembly for continuity, since a failed switch prevents the washer from spinning with the lid closed. Enter your ARDO washing machine model number to find the exact replacement part for your specific washer and verify fit before ordering.
01 - ARDO Washing Machine Rotor and Stator Kit
The stator is part of a direct drive motor that electrically drives the outer rotor. If the stator coils become wet or the coated wires on the coils short out, they can produce a burning smell. You can test the stator coils with a meter. If the stator is smoking, or smells burnt, it will need to be replaced.
Enter model number to search for the required part specific to your product
The motor coupling connects the motor to the washer transmission. If the washer is overloaded, the motor coupling will fail in order to protect both the motor and transmission. The motor coupling can also fail due to normal wear. Inspect the motor coupling to determine if it is broken. If the motor coupling is broken, replace it.
Since a washing machine control board provides voltage to nearly all of the washer's electrical components, a faulty board may not be sending power to the drive motor during the wash or spin cycle. If power is not reaching the drive motor, you should first confirm the lid or door switch test properly with a multimeter. If the lid or door switch is working properly, the control board is likely at fault. You can inspect the board for signs of burning or a shorted-out component. You can also use a multimeter to test the power output terminals on the board after reviewing the appliance's wiring diagram.
If a washer is not spinning or agitating, you should first determine if the drive motor is running and if power is reaching the drive motor. If no power if reaching the drive motor, and the lid swith assembly or door latch test appropriately with a multimeter, then the timer is likely malfunctioning. Since this is rarely the case, you should confirm all of the other likely defective components are functioning normally before considering a timer replacement.
The lid switch assembly prevents the washer from spinning when the lid is open. If the lid switch assembly fails, the washer will not spin. To determine if the lid switch assembly is defective, use a multimeter to test the lid switch for continuity. If the lid switch does not have continuity, replace it.