A Roper washer burning smell usually points to an electrical component or a slipping belt that is overheating. The most likely cause is a failed rotor and stator kit: wet stator coils or shorted coated wires can produce a washer burning smell, and a smoking or visibly burnt stator requires replacement. Next, inspect the main control board, motor control board, and control board for burn marks caused by a power surge or failed component. If the smell is more like burning rubber, check the water pump belt and drive belt. A worn pump belt can slip on the pulleys, while a frayed drive belt can create friction, especially if the water pump or idler pulley is stuck and cannot turn freely. Unplug the Roper washing machine before inspecting parts, and do not operate it if you see smoke or melted wiring. Enter your model number to find the exact replacement part for your specific washing machine, including the correct rotor and stator kit, control board, motor control board, water pump belt, or drive belt.
01 - Roper Washing Machine Rotor and Stator Kit
The stator is part of a direct drive motor that electrically drives the outer rotor. If the stator coils become wet or the coated wires on the coils short out, they can produce a burning smell. You can test the stator coils with a meter. If the stator is smoking, or smells burnt, it will need to be replaced.
Enter model number to search for the required part specific to your product
The main control board provides power to the various components of the washer. If the control board receives a power surge, or a component fails, the control board can short-out causing a burning smell. Inspect the control board for burn marks. A burnt main control board will need to be replaced.
The motor control board sends power to the motor. If the motor shorts out or a power surge occurs components on the board can blow out causing a burning smell. Inspect the motor control board for burn marks and replace if necessary.
The control board provides power to the components of the washer. If the control board receives a power surge or a component fails, the control board can short out causing a burning smell. Inspect the control board for burn marks. If the control board is burnt, it will need to be replaced.
The water pump belt can get worn and slip on the pulleys causing a burning smell. Check the motor pulley for wear and make sure the water pump turns freely.
If the drive belt is worn or frayed it can slip on the pulley causing friction and a burning smell. Also check the components the belt is turning to make sure they turn freely. A stuck water pump or idler pulley can create enough friction to cause the belt to burn.