Roper Parts

Oven bake or broil igniter, 2.5 to 3.0 Amp. The igniter draws electrical current through the oven safety valve to open it. If the igniter glows for more than 90 seconds without igniting the gas flame, this indicates that the igniter is too weak to open the valve. (NOTE: This part is very fragile.)

Washing machine lid switch assembly with wire harness. The lid switch ensures that the washer door is closed while the washer is spinning. If the lid switch is broken, the washer will not spin. If the washer won't spin but will still agitate, the lid switch is likely defective.

Door seal

Upper dishrack roller assembly

Dryer LP conversion kit; Natural gas to LP (liquid propane). This kit includes the orifice, leak limiter, and instruction sheet.

Compressor run capacitor

Dryer lint screen assembly without handle

Refrigerator water filter housing. Has 5/16 inch & ¼ inch quick connections built into it. Push down on rings at tubing to release.

Refrigerator defrost thermostat. The thermostat clips onto the evaporator. If the refrigerator does not defrost both the thermostat and heater can be tested to determine which part is at fault.

Surface element control switch (also called the infinite switch) for 6-inch element. The surface element switch sends voltage to the surface element coil

Lower access panel

Suspension Ball Kit
Please use your model number to order complete suspension rod kit that will include the suspension rods and balls

Oven door gasket

Dryer lint screen assembly. Proper air flow is critical to dryer operation so the filter should be cleaned before every load.

Door bar support cap