MTD Parts

Briggs & Stratton starter gear (also called a pinion gear), 16-tooth, plastic. The starter gear engages the flyhweel to start the engine. If the teeth on the starter gear are worn out, the engine may not start.

Snow blower slide shoe in black. 3" W x 4 3/4"L

Extension spring, .380 x 2.500

Briggs & Stratton exhaust push rod, steel.

Riding lawn mower blade spindle assembly. Fits 5 star blade mounting holes. Mounting holes are not pre-threaded, new self tapping mounting screw are recommended. See related parts.

Lawn mower ring cip.

Replacement Briggs & Stratton fuel line kit with clamps. 1/4 Inch inside diameter, Cut to length.

Briggs & Stratton in-line fuel filter. The filter screen is on the large side of the housing. The port on the large side goes to the fuel tank while the port on the small side of the housing goes to the carburetor.

MTD flange lock nut, 5/16-18.

Lawn mower front wheel flange bearing. (2) required for each wheel. It is recomended to replace both at the same time.

Carburetor gasket

Snow blower control cable for the auger assembly. If the snow thrower auger does not engage, check the cable for damage.

Lawn mower blade adapter. 25mm. If the lawn mower's blade isn't engaging properly, the blade adapter may be stripped. If the blade adapter is stripped, replace it.

Two cycle engine carburetor. If the engine runs rough, the carburetor may be restricted. The carburetor can often be cleaned or rebuilt, but sometimes it may need to be replaced.

Small engine carburetor gasket. If the gasket is torn or damaged the engine may run rough.