Kenmore Heating Element Parts

Range/stove surface element (6-inch). If the surface element won't heat, either the surface element or the surface element switch may be defective. To determine if the surface element is defective, use a multimeter to test it for continuity.

Surface coil element replacement kit, 2 eight inch elements, 2 six inch elements, four receptacles and related hardware. If the terminal blocks and surface elements on your stove top are in bad shape this is the perfect kit to refresh the appliance.

The Whirlpool Bake Element is a high quality part located at the bottom of the oven that supplies heat for baking. It is 16-5/8 inches wide X 15-3/4 inches deep and is for electric ovens on ranges with a rating of 2600Watt and 240Volt. It replaces multiple part numbers. Use caution when servicing.

The Whirlpool Bake Element is a high quality part located at the bottom of the oven that supplies heat for baking. It measures 15-5/8 inches Length by 15 inches Width and is for electric ovens with a rating of 2100 Watt and 240 Volt. It replaces multiple part numbers.

Oven bake element with push-on terminal ends. It is not unusual for a bake element to short out and arc in one spot. If this occurs, disconnect the power to the stove until the element has been replaced.

Bake element assembly

This Frigidaire heating element assembly is a genuine replacement part for dryers, ensuring smooth operation and perfectly dry clothes. Compatible with various models.

Oven bake element. The terminals are male quarter inch spade connectors. The wires push onto the heating elements connectors. If the oven does not bake then the element could have burned out.

Dual radiant surface element 3000/1400 watt

Radiant surface element, 9-inch 2500 Watt

Oven bake element. It is not unusual for a heating element to short in one spot and arc. When this occurs the power should be shut off to oven and the not restored until after the element is replaced.

Radiant surface element, 6-inch 1200 Watts

Dual surface element, 9 inches/ 6 inches. 1200/1300 Watt

The GE Defrost Heater and Bracket Assembly WR51X10055 is a high quality OEM part that melts frost from the evaporator fins during automatic defrost cycles. It is also known as the Refrigerator Glass Tube Defrost Heater and Bracket Assembly. Disconnected from all utilities prior to repair.

Dryer heating element assembly. If the dryer no longer heats then the heating element may have failed, but it is not the most common cause. The most common cause for a dryer to stop heating is a blown thermal fuse.