Payne HVAC Parts

Gas burner tube

Furnace draft inducer mounting grommet. This grommet helps isolate the blower assembly from the furnace to reduce noise.

Gasket

Grommet, sold individually

Screw-grille mounting

Furnace draft inducer motor. The draft inducer motor draws air into the burner and exhausts it out the flue. If the draft inducer motor is defective, the furnace may not heat.

Condensate trap

Latch-filter cover

Furnace draft inducer motor with cooling fan. Be aware that the screw holes are not threaded—you will need to use self-tapping screws to install the motor.

Furnace draft inducer motor cooling fan blade and clip. You may have to cut the old clip off to remove the fan blade.

Run cap 35/5mfd/440v/dual round

Furnace flame sensor. The flame sensor monitors the burner to detect whether or not a flame is present. If the flame sensor is defective, the furnace may not heat.

Limit switch

Furnace blower wheel. 12" X 11.93" 1/2" Bore. The blower wheel blows air out of the furnace and through the house. The blower wheel is attached to the blower motor shaft with a set screw. If the set screw is loose, the blower wheel will wobble on the motor shaft and be noisy as it turns.

Run Capacitor, Single, Oval, 370 Volts, 5 Microfarads