Tempstar HVAC Parts

Flame rollout switch 300F resetable

Furnace Draft Inducer Motor 1013833. The motor ensures safe and proper operation by drawing air into the burner and expelling it from the flue. Failure can result in inadequate exhaust or venting in your furnace. Compatible brands include Comfortmaker, Tempstar, Heil, ICP, and Arcoaire.

Control fan timer

Hot surface furnace igniter kit.
If the electrical connnector on your old part is different than the new igniter, it can be cut off and spliced onto the new igniter wires using the provided wire nuts.

Furnace draft inducer motor. The draft inducer motor draws air into the burner and exhausts it out the flue. If the draft inducer motor is defective, the furnace may not heat.

Pressure switch

Contactor 1 pole 25 amp 24 volt

Single run capacitor, oval, 370 volts, 10 microfarads

Triple-D Coil Cleaner is a 19oz Aerosol spray can, that is safe for homeowner use. One can will clean an entire outdoor condenser coil and/or indoor evaporator coil, to remove energy-stealing dirt, debris and soot.

Blower Wheel 11"x10" CW 1/2"Bore

3 Blade fan, 18" diameter 28 degree 1/2" CW

Condenser Fan Motor, 1/6 HP, 208/230 Volts, 60 Hertz, 0.99 Amps, 1100 RPM, Single Speed, Closed Enclosure, 42Y Frame, Single Phase, Reversible Rotation, 1.75" Shaft

Condenser fan motor. This single-phase motor has the following specifications:

Horsepower: 1/5
Voltage: 208-230
Full-Load Amperage: 1.3
Hertz: 60
RPM: 1075
Rotation: counterclockwise
Frame: 48
Enclosure: Closed
Shaft Length: 2.5”

Pilot and spark igniter assembly

Burner asy 4-sect