Shop replacement repair parts for Carrier Furnace model 340MAV036080ABKA

Flame rollout limit switch, re-settable. opens at 250f

Carrier furnace igniter. The igniter gets very hot and glows bright orange to light the gas burner. If the igniter is cracked or defective, the furnace won’t heat.

Furnace flame sensor. The flame sensor monitors the burner to detect whether or not a flame is present. If the flame sensor is defective, the furnace may not heat.

Run Capacitor, Single, Oval, 370 Volts, 5 Microfarads

Elbow

Furnace control board. The control board regulates the supply of power to the furnace components. Be sure to check more commonly defective parts before replacing the control board.

Transformer, 120V-24V 40VA

Pressure switch, SPST 1.65"wc, 1/4 barbed connection

Inducer motor assembly. This assembly is designed for 40, 60, 80, and 100 thousand BTU model furnaces. Your furnace's BTU rating may be listed on the model number tag. You can also determine the rating from your model number—the 3-digit number preceding the hyphen indicates the BTU rating.

Furnace blower motor. This single-phase motor has the following specifications:
Horsepower: 1/3
Voltage: 115
Full-Load Amperage: 5.2
Hertz: 60
RPM: 1075
Speeds: 4
Rotation: Counterclockwise
Frame: 48
Enclosure: Open
Shaft Length: 3.9”

Run capacitor 3.0uf 250v

Gas valve kit. *Should be installed by a certified Carrier repairperson.

High limit thermostat, 250 degrees Fahrenheit

Pressure switch

Blower housing assy