Shop replacement repair parts for Carrier Furnace model 376CAV024050AFJA

Furnace flame sensor. The flame sensor monitors the burner to detect whether or not a flame is present. If the flame sensor is defective, the furnace may not heat.

Single run capacitor 440V 7.5 mfd

Furnace draft inducer motor with cooling fan. Be aware that the screw holes are not threaded—you will need to use self-tapping screws to install the motor.

Limit switch

Furnace control board. The control board regulates the supply of power to the furnace components. Be sure to check more commonly defective parts before replacing the control board.

Transformer, 120V-24V 40VA

Igniter replacement kit

Pressure switch

Gas valve kit. *Should be installed by a certified Carrier repairperson.

High limit thermostat, 220 degrees Fahrenheit

Manual reset switch, opens at 350 degrees F

Blower motor, 1/5 HP, 115 volts, 60 Hz, 2.5 amps, 1075 RPM's, 3 speed, open enclosure, single phase, 4.5" shaft, counterclockwise rotation

Harness wire

Pilot burner orifice

Vacuum tube