Shop replacement repair parts for Carrier Furnace model 393AAV060135FBJA

Furnace flame sensor. The flame sensor monitors the burner to detect whether or not a flame is present. If the flame sensor is defective, the furnace may not heat.

Furnace draft inducer motor with cooling fan. Be aware that the screw holes are not threaded—you will need to use self-tapping screws to install the motor.

Limit switch

Furnace control board. The control board regulates the supply of power to the furnace components. Be sure to check more commonly defective parts before replacing the control board.

Transformer, 120V-24V 40VA

Igniter replacement kit

Pressure switch

Gas valve kit. *Should be installed by a certified Carrier repairperson.

High limit thermostat, 250 degrees Fahrenheit

Carrier furnace blower motor. This single-phase motor has the following specifications:
Horsepower: ¾
Voltage: 115
FLA (full load amps): 11.1
RPM: 1075
Speeds: 4
Rotation: CCW
Frame: 48
Shaft Length: 4”

Blower housing asy

Wire harness

Limit switch

Pilot burner orifice

Vacuum tube