Shop replacement repair parts for Carrier Furnace model 395CAV036045AHJA

Furnace flame sensor. The flame sensor monitors the burner to detect whether or not a flame is present. If the flame sensor is defective, the furnace may not heat.

Single run capacitor 440V 7.5 mfd

Furnace draft inducer motor with cooling fan. Be aware that the screw holes are not threaded—you will need to use self-tapping screws to install the motor.

Limit switch

Furnace control board. The control board regulates the supply of power to the furnace components. Be sure to check more commonly defective parts before replacing the control board.

Transformer, 120V-24V 40VA

Furnace blower motor. This single-phase motor has the following specifications:
Horsepower: 1/3
Voltage: 115
Full-Load Amperage: 5.2
Hertz: 60
RPM: 1075
Speeds: 4
Rotation: Counterclockwise
Frame: 48
Enclosure: Open
Shaft Length: 3.9”

Igniter replacement kit

Pressure switch

Gas valve kit. *Should be installed by a certified Carrier repairperson.

Limit switch, 160 degree

Wire harness

Pilot burner orifice

Vacuum tube