Price Match GuaranteeLennox Furnace G50UH-48C-110-15 Parts
Shop replacement repair parts for Lennox Furnace model G50UH-48C-110-15
Furnace flame sensor. The flame sensor monitors the burner to detect whether or not a flame is present. If the flame sensor is defective, the furnace may not heat.
Furnace Igniter (80 volt) *** please see related item if 120 volt igniter is needed***
Limit rollout control
Capacitor single run 7.5 MFD 370 Volt oval
Furnace draft inducer motor.115Volts 60Hz 1.2 amp 3000 RPM's Closed Enclosure. The draft inducer motor draws air into the burner and exhausts it out the flue. If the draft inducer motor is defective, the furnace may not heat.
1/2HP 115Volts 60Hz 8 amp 1075 RPM's 5 Speed Open Enclosure 48Y Frame Single Phase CCW 3" Shaft. Any unused wires will need to be taped off or put on the "park" terminals on the control board. These terminals are there specifically for unused wires.
Pressure switch
Pressure switch
Limit control, 135 f
Transformer 40va 120/24
Furnace control board. The control board regulates the supply of power to the furnace components. Be sure to check more commonly defective parts before replacing the control board.
Harness-wiring
Harness-wiring
Harness-wiring
Flame sensor wire
Frequently Purchased Together For This Model
Family-owned and operated since 1912, Burke America Parts Group is the longest-running genuine appliance, HVAC, and outdoor power equipment parts solution in North America. At Repair Clinic, we're proud to be an international brand trusted by the pros as well as the DIY community.
About Repair Clinic