Whirlpool Dryer YQCEM2733BQ0 Parts

The Dryer Repair & Maintenance Kit 4392065 includes rollers, a belt, and an idler pulley. It is specifically designed for 29 wide dryers built in 1965 or later. This kit addresses common issues that cause Whirlpool, Kenmore, Maytag, and KitchenAid dryers to become noisy.

Dryer thermal fuse. Opens at approximately 196°F (91°C). *If open check for air flow issues like plugged exhaust vent or damaged blower wheel

Dryer heating element assembly. If the dryer does not heat the thermal fuse should be checked before replacing the heating element. Normally, the element will have a break in the coil if defective.

Dryer drum support roller. If the dryer is making a rumbling or knocking noise the rollers may be worn out causing the drum not to turn smoothly.

Dryer drum drive belt, 93 1/2 inches long, 4 ribs 3 grooves. The drive belt is a very long, slender belt that wraps all the way around the dryer drum, around a tension pulley, and then around the drive motor pulley. If the drum will not turn when the dryer is turned on the belt is likely broken.

Dryer door switch assembly. If the dryer does not start then the door switch could be defective. This switch also replaces the two wire switch.

Dryer high limit thermostat and thermal fuse kit. If the dryer does not heat the most common cause is a blown thermal fuse. Both the thermostat and fuse can be tested to determine if either is defective.352 F fuse. L146.1-44.4c thermostat.

Dryer lint filter. Air flow is vital to proper dryer operation. The lint filter should be cleaned before every load and replaced if damaged.

Dryer door catch kit

Dryer drum felt seal kit. Includes silicone rubber adhesive.

Motor pulley, 60 hertz

Dryer tri-ring retainer for drum support rollers.

Outer grille

White Touch Up Paint

Screw, 10-24 x 1/2