Shop replacement repair parts for Trane Furnace model TDD120C960C1

Furnace flame sensor. The flame sensor monitors the burner to detect whether or not a flame is present. If the flame sensor is defective, the furnace may not heat.

Stainless steel burner

Run Capacitor, 10 uf, 440 VAC

Hot surface furnace ignitor with plug on connector

Transformer; 115v pri, 24v sec., 60hz, 35va, foot mount

Control; fuse link, open at 333 deg f

Draft Inducer Motor, 1 stage. The draft inducer motor draws air into the burner and exhausts it out the flue. If the draft inducer motor is defective, the furnace may not heat.

Blower Wheel 11.7 by 10.6 inches.

Gasket; venter assembly

Brass orifice spud, drill #45

Resilient ring, 2 required

Thermal limit switch

3/4HP 115Volts 60Hz 12 amp 1075 RPM's 4 Speed Open Enclosure 48Y Frame Single Phase CCW 3" Shaft

Wire; ignitor harness assembly w/4 pin male connect
