Shop replacement repair parts for Trane Furnace model TUD120R954H5

Furnace flame sensor. The flame sensor monitors the burner to detect whether or not a flame is present. If the flame sensor is defective, the furnace may not heat.

Stainless steel burner

Hot surface furnace ignitor with plug on connector

Transformer; 115v pri, 24v sec., 60hz, 35va, foot mount

Thermal limit switch, open at 190 degrees, close at 160 degrees F

Blower Wheel 11.7 by 10.6 inches.

Gasket; venter assembly

Door switch, 21 amps, 125/250 vac

1/2HP 115Volts 60Hz 9.35 amp 1075 RPM's 4 Speed Open Enclosure 48Y Frame Single Phase CCW 3" Shaft

Brass orifice spud, drill #45

Resilient ring, 2 required

Integrated, two stage, control board. The control board regulates the supply of power to the furnace components. Be sure to check more commonly defective parts before replacing the control board.

Wire; replacement wiring harness asm, includes 12 p

Tube; pressure switch, stainless steel, .025 o.d. .
