Shop replacement repair parts for Trane Furnace model TUE100A960L3

Furnace flame sensor. The flame sensor monitors the burner to detect whether or not a flame is present. If the flame sensor is defective, the furnace may not heat.

HSI control module with four wire leads The HSIcontrol module regulates the supply of power to the furnace components. Be sure to check more commonly defective parts before replacing the control board.

Flame rollout switch. Push red button to reset. L310

Hot surface furnace ignitor with plug on connector

Gas Valve Assembly
Please see related items for gas valve adapter kit

Thermal limit switch, open at 190 degrees, close at 160 degrees F

Draft Inducer Motor, 1 stage. The draft inducer motor draws air into the burner and exhausts it out the flue. If the draft inducer motor is defective, the furnace may not heat.

Pressure switch SPNO 50" WC

1/2HP 115Volts 60Hz 9.35 amp 1075 RPM's 4 Speed Open Enclosure 48Y Frame Single Phase CCW 3" Shaft

Wire;12 pin wire harness assembly

Wire;harness ignitor to control to induced draft bl

Blower motor assembly

Transformer; 115v-pri 24v-sec 35va

Capacitor; run, 15 mfd, 370vac, oval, w/o resistor