Shop replacement repair parts for Trane Furnace model TUE100A960L3

Furnace flame sensor. The flame sensor monitors the burner to detect whether or not a flame is present. If the flame sensor is defective, the furnace may not heat.

Stainless steel burner

HSI control module with four wire leads The HSIcontrol module regulates the supply of power to the furnace components. Be sure to check more commonly defective parts before replacing the control board.

Flame rollout switch. Push red button to reset. L310

Hot surface furnace ignitor with plug on connector

Gas Valve Assembly
Please see related items for gas valve adapter kit

Thermal limit switch, open at 190 degrees, close at 160 degrees F

Draft Inducer Motor, 1 stage. The draft inducer motor draws air into the burner and exhausts it out the flue. If the draft inducer motor is defective, the furnace may not heat.

Blower Wheel 11.7 by 10.6 inches.

Gasket; venter assembly

Pressure switch SPNO 50" WC

Door switch, 21 amps, 125/250 vac

1/2HP 115Volts 60Hz 9.35 amp 1075 RPM's 4 Speed Open Enclosure 48Y Frame Single Phase CCW 3" Shaft

Brass orifice spud, drill #45

Wire;12 pin wire harness assembly