Shop replacement repair parts for Trane Furnace model TUE140A960K3

Furnace flame sensor. The flame sensor monitors the burner to detect whether or not a flame is present. If the flame sensor is defective, the furnace may not heat.

Stainless steel burner

HSI control module with four wire leads The HSIcontrol module regulates the supply of power to the furnace components. Be sure to check more commonly defective parts before replacing the control board.

Hot surface furnace ignitor with plug on connector

Gas Valve Assembly
Please see related items for gas valve adapter kit

Transformer; 115v pri, 24v sec., 60hz, 35va, foot mount

Draft Inducer Motor, 1 stage. The draft inducer motor draws air into the burner and exhausts it out the flue. If the draft inducer motor is defective, the furnace may not heat.

Blower Wheel 11.7 by 10.6 inches.

Capacitor; 440 vac oval motor run, 15 mfd

Door switch, 21 amps, 125/250 vac

Brass orifice spud, drill #45

Resilient ring, 2 required

Air Filter, 25" x 24" x 1". Permanent

Blower motor, 3/4HP, 115 volts, 60 hertz, 9.6 amps 1075 RPM's, 4 Speed Open Enclosure, 48Y Frame, Single Phase CCW 3" Shaft

Wire;12 pin wire harness assembly