Shop replacement repair parts for Trane Furnace model TUH1B040A9H21BA

Furnace flame sensor. The flame sensor monitors the burner to detect whether or not a flame is present. If the flame sensor is defective, the furnace may not heat.

Stainless steel burner

Hot Surface Ignitor Kit

Switch; switch-flame rollout, 82 degrees c, 180 deg

Transition receptacle, includes four mounting screws

Door switch, 21 amps, 125/250 vac

Thermal limit switch, open at 230F, close at 200F.

Brass orifice spud, drill #45

Natural Gas To LP Gas Conversion Kit. Kit includes, 7 orifice main burner #56, 1 LP spring conversion kit, 1 propane label, 1 conversion label, 1 conversion responsibility label, 1 installer's guide. *Should be installed by a certified Trane repairperson.

Intergrated furnace control board. The control board regulates the supply of power to the furnace components. Be sure to check more commonly defective parts before replacing the control board.

Gasket;collector box

Switch; limit inducer

Grommet, burner box entry seal

Furnace draft inducer motor. The draft inducer motor draws air into the burner and exhausts it out the flue. If the draft inducer motor is defective, the furnace may not heat.

Filter; permanent, 25 x 16.5 x 1in.