Shop replacement repair parts for Trane Furnace model TUX100C948B5

Furnace flame sensor. The flame sensor monitors the burner to detect whether or not a flame is present. If the flame sensor is defective, the furnace may not heat.

Stainless steel burner

HSI control module with four wire leads The HSIcontrol module regulates the supply of power to the furnace components. Be sure to check more commonly defective parts before replacing the control board.

Hot surface furnace ignitor with plug on connector

Transformer; 115v pri, 24v sec., 60hz, 35va, foot mount

Thermal limit switch, open at 190 degrees, close at 160 degrees

Transition receptacle, includes four mounting screws

Door switch, 21 amps, 125/250 vac

1/2HP 115Volts 60Hz 9.35 amp 1075 RPM's 4 Speed Open Enclosure 48Y Frame Single Phase CCW 3" Shaft

10 in diameter x 10 in width. .50 BC. Clockwise rotation

Brass orifice spud, drill #45

Resilient ring, 2 required

Draft inducer motor, one stage, ball bearing.The draft inducer motor draws air into the burner and exhausts it out the flue. If the draft inducer motor is defective, the furnace may not heat.

Wire; harness assembly, including inducer/ignitor h

Wire; ignition harness