Shop replacement repair parts for Trane Furnace model TUX100C960B5

Furnace flame sensor. The flame sensor monitors the burner to detect whether or not a flame is present. If the flame sensor is defective, the furnace may not heat.

Stainless steel burner

HSI control module with four wire leads The HSIcontrol module regulates the supply of power to the furnace components. Be sure to check more commonly defective parts before replacing the control board.

Hot surface furnace ignitor with plug on connector

Transformer; 115v pri, 24v sec., 60hz, 35va, foot mount

Blower Wheel 11.7 by 10.6 inches.

Transition receptacle, includes four mounting screws

Door switch, 21 amps, 125/250 vac

Brass orifice spud, drill #45

Draft inducer motor, one stage with shaded pole motor *Note: All models use this part with the exception of: *UX/DX100A, UX/DX100C, UX/DX1C100, UX1D100, UX/DX120A, UX/DX120C. These select models use item 2458691.

Resilient ring, 2 required

Switch; thermal limit, open 200f, close 170f

Air Filter, 25" x 24" x 1". Permanent

Blower motor, 3/4HP, 115 volts, 60 hertz, 9.6 amps 1075 RPM's, 4 Speed Open Enclosure, 48Y Frame, Single Phase CCW 3" Shaft

Wire; harness assembly, including inducer/ignitor h