Shop replacement repair parts for Goodman Packaged Unit/RTU model GPG10240701A

Furnace flame sensor. The flame sensor monitors the burner to detect whether or not a flame is present. If the flame sensor is defective, the furnace may not heat.

Contactor, 2 pole, 30 amp, 24 vac **Special Note** This may replace single pole contactor and require a technican to install (based on model #)

Beckett burner

Gas valve, 24v 3.5" wc

.43 Natural gas burner orifice

10"x8" blower wheel

Furnace draft inducer motor. The draft inducer motor draws air into the burner and exhausts it out the flue. If the draft inducer motor is defective, the furnace may not heat.

Pressure switch,(-)0.33pr

Ignition control board. The ignition control board regulates the supply of power to the furnace components. Be sure to check more commonly defective parts before replacing the control board.

Condenser Fan Motor - 1/6 HP 208-230Volts 60Hertz 1Amps 1075RPM Single Speed Closed Enclosure Frame Single Phase CCW Rotation 3" Shaft

Nut, acorn 5/16 hex black

Spark igniter

Cap, 15 mfd/440v/oval

Run Capacitor 440 Volt Round Dual 30/5 MFD

Limit switch - manual reset