Shop replacement repair parts for Carrier Furnace model GB1AAV060125AAJA

Furnace flame sensor. The flame sensor monitors the burner to detect whether or not a flame is present. If the flame sensor is defective, the furnace may not heat.

Furnace draft inducer motor with cooling fan. Be aware that the screw holes are not threaded—you will need to use self-tapping screws to install the motor.

Limit switch

Transformer, 120V-24V 40VA

Igniter replacement kit

Pressure switch

Gas valve kit. *Should be installed by a certified Carrier repairperson.

Manual reset switch, opens at 350 degrees F

Limit switch, 160 degree

Furnace control board. The control board regulates the supply of power to the furnace components. Be sure to check more commonly defective parts before replacing the control board.

3/4HP 115Volts 60Hz 11.1 amp 1075 RPM's 4 Speed Open Enclosure 48Y Frame Single Phase CCW 4" Shaft

The control board regulates the supply of power to the furnace components. Be sure to check more commonly defective parts before replacing the control board.

Blower housing asy

Harness wire

Wiring harness