Shop replacement repair parts for Carrier Furnace model GB3AAV060115AGJA

Furnace flame sensor. The flame sensor monitors the burner to detect whether or not a flame is present. If the flame sensor is defective, the furnace may not heat.

Furnace draft inducer motor with cooling fan. Be aware that the screw holes are not threaded—you will need to use self-tapping screws to install the motor.

Limit switch

Furnace control board. The control board regulates the supply of power to the furnace components. Be sure to check more commonly defective parts before replacing the control board.

Transformer, 120V-24V 40VA

Igniter replacement kit

Pressure switch

Gas valve kit. *Should be installed by a certified Carrier repairperson.

Limit switch

Carrier furnace blower motor. This single-phase motor has the following specifications:
Horsepower: ¾
Voltage: 115
FLA (full load amps): 11.1
RPM: 1075
Speeds: 4
Rotation: CCW
Frame: 48
Shaft Length: 4”

High limit switch

Harness wire

Pilot burner orifice

Vacuum tube