Price Match GuaranteeWhirlpool Dryer WED8000DW0 Parts
Shop replacement repair parts for Whirlpool Dryer model WED8000DW0
Dryer drum support roller. If the dryer is making a rumbling or knocking noise the rollers may be worn out causing the drum not to turn smoothly.
RC Item #587637
The Dryer Maintenance Kit 4392067 includes drum support rollers, a multi-rib belt, an idler pulley wheel, triangle clips, and a washer for a complete maintenance overhaul. If your Whirlpool, Kenmore, or Maytag dryer is making loud noises or the drum is not turning, it may be time for replacement.
Dryer idler pulley assembly. Includes bracket and pulley wheel
Door catch
Dryer thermistor. This thermistor should read approximately 11.9K Ohms of resistance at 70 degrees Fahrenheit (21’ Celsius). If the thermistor is defective, it may prolong or shorten the drying time or cause a fault code. A defective thermistor is not responsible for a dryer not heating.
Dryer high limit thermostat and thermal fuse kit. If the dryer does not heat the most common cause is a blown thermal fuse. Both the thermostat and fuse can be tested to determine if either is defective.352 F fuse. L146.1-44.4c thermostat.
Dryer idler pulley wheel kit. The idler pulley puts tension on the drive belt. If the idler pulley fails to put the proper amount of tension on the belt, the dryer will not spin
Dryer thermal fuse located on the blower housing. If the dryer overheats, the thermal fuse blows cutting off power to the motor or the heating system. When the fuse is bad the dryer won't start or will run but not heat. The thermal fuse cannot be reset. Fuses often blow due to a clogged dryer vent.
Plastic leveling leg. White approximately 1" round x 1 3/4" long
The Whirlpool Blower Wheel WP697772 is a high-quality replacement part that attaches to the drive motor shaft and blows air through the drum and out through the exhaust vent. It is important to use safety equipment and disconnect the appliance before any service or repair.
Dryer heating element wire connector kit. Wire with spade terminal & wire nut
Dryer tri-ring retainer for drum support rollers.
White Touch Up Paint
Screw, 10-24 x 1/2
Shaft for dryer drum support roller. Rear shaft with left hand threads. Part is updated so nuts may need to be replaced as well on older dryers.
Frequently Purchased Together For This Model
Family-owned and operated since 1912, Burke America Parts Group is the longest-running genuine appliance, HVAC, and outdoor power equipment parts solution in North America. At Repair Clinic, we're proud to be an international brand trusted by the pros as well as the DIY community.
About Repair Clinic