Shop replacement repair parts for York Furnace model CM9M100C20MP11

Furnace hot surface igniter kit. The igniter gets very hot and glows bright orange to light the gas burner. If the igniter is cracked or defective, the furnace won’t heat.

Furnace flame sensor. The flame sensor monitors the burner to detect whether or not a flame is present. If the flame sensor is defective, the furnace may not heat.

Limit thermostat, 150 open, 110 close

Flame rollout limit switch, push button to re-set

Furnace draft inducer motor. The draft inducer motor draws air into the burner and exhausts it out the flue. If the draft inducer motor is defective, the furnace may not heat.

Furnace blower motor. This single-phase motor has the following specifications:
Horsepower: 1
Voltage: 115
Full-Load Amperage: 14.4
Hertz: 60
RPM: 1075
Speeds: 4
Rotation: Counterclockwise
Frame: 48
Enclosure: Open
Shaft Length: 3"

Transformer 120v-pri 24v-sec 40va

Switch,pres,air,0.67 iwc on fall,spno

Sensor,pressure

Switch,pres,air,-0.15 iwc on fall,spno

Single run capacitor, 15 MFD, 370 volts, oval

Gas valve, 97% modulating,gen2

Furnace control board upgrade kit. The control board regulates the supply of power to the furnace components. Be sure to check more commonly defective parts before replacing the control board.

Switch,pres,air,-0.67 iwc on fall,spno

Furnace control board. The control board regulates the supply of power to the furnace components. Be sure to check more commonly defective parts before replacing the control board.