Shop replacement repair parts for York Furnace model G9T04010DHA13

Furnace control board. The control board regulates the supply of power to the furnace components.

Furnace hot surface igniter kit. The igniter gets very hot and glows bright orange to light the gas burner. If the igniter is cracked or defective, the furnace won’t heat.

Genteq Run Capacitor 370 Volt Oval Single 7.5 MFD

Gas valve kit

Furnace flame sensor. The flame sensor monitors the burner to detect whether or not a flame is present. If the flame sensor is defective, the furnace may not heat.

Pressure switch

Furnace blower motor. This single-phase motor has the following specifications:
Horsepower: 1/3
Voltage: 115
Full-Load Amperage: 6.2
Hertz: 60
RPM: 1075
Speeds: 4
Rotation: Counterclockwise LE
Frame: 48
Enclosure: Open
Shaft Length: 4”

Furnace draft inducer motor assembly. The draft inducer motor draws air into the burner and exhausts it out the flue. If the draft inducer motor is defective, the furnace may not heat.

Transformer, 120 volt primary 24 volt secondary 40 va

Switch,pres,air,1.20/0.40-deact-n/o

Limit Switch

Temperature control, manual close, opens at 140 degrees

Flame rollout limit switch. 200'F open, manual close