Shop replacement repair parts for York Furnace model GG8S120C20MP11

Furnace control board. The control board regulates the supply of power to the furnace components.

Furnace hot surface igniter kit. The igniter gets very hot and glows bright orange to light the gas burner. If the igniter is cracked or defective, the furnace won’t heat.

Furnace flame sensor. The flame sensor monitors the burner to detect whether or not a flame is present. If the flame sensor is defective, the furnace may not heat.

Flame rollout limit switch, push button to re-set

Furnace blower motor. This single-phase motor has the following specifications:
Horsepower: 1
Voltage: 115
Full-Load Amperage: 14.4
Hertz: 60
RPM: 1075
Speeds: 4
Rotation: Counterclockwise
Frame: 48
Enclosure: Open
Shaft Length: 3"

Gas valve kit

Air pressure switch

Transformer 120v-pri 24v-sec 40va

Switch,pres,air,0.67 iwc on fall,spno

Single run capacitor, 15 MFD, 370 volts, oval

Furnace draft inducer motor. The draft inducer motor draws air into the burner and exhausts it out the flue. If the draft inducer motor is defective, the furnace may not heat.

Harness,wire