Shop replacement repair parts for York Furnace model GM9T100C16UP11

Furnace hot surface igniter kit. The igniter gets very hot and glows bright orange to light the gas burner. If the igniter is cracked or defective, the furnace won’t heat.

Run capacitor, single,10mfd,370 volts, oval

Furnace flame sensor. The flame sensor monitors the burner to detect whether or not a flame is present. If the flame sensor is defective, the furnace may not heat.

3/4HP 115Volts 60Hz 11 amp 1060 RPM's 3 Speed Open Enclosure 48Y Frame Single Phase CCW 3.5" Shaft

Transformer, 120 volt primary 24 volt secondary 40 va

Auto reset limit control

Furnace control board. The control board regulates the supply of power to the furnace components. Be sure to check more commonly defective parts before replacing the control board.

Draft Inducer Motor Assembly, 2-stage kit. The draft inducer motor draws air into the burner and exhausts it out the flue. If the draft inducer motor is defective, the furnace may not heat.

Gas valve, 2-stage, J style

Switch,pres,air,0.60/1.05 on fall,spno

Board,cntrl,integr furnace-st

Flame rollout limit switch. 200'F open, manual close