Shop replacement repair parts for York Furnace model GY8S100B12DN11

Furnace control board. The control board regulates the supply of power to the furnace components.

Furnace hot surface igniter kit. The igniter gets very hot and glows bright orange to light the gas burner. If the igniter is cracked or defective, the furnace won’t heat.

Furnace flame sensor. The flame sensor monitors the burner to detect whether or not a flame is present. If the flame sensor is defective, the furnace may not heat.

Genteq Run Capacitor 370 Volt Oval Single 7.5 MFD

Furnace blower motor. This single-phase motor has the following specifications:
Horsepower: 1/2
Voltage: 115
Full-Load Amperage: 7.7
Hertz: 60
RPM: 1175
Speeds: 4
Rotation: Counterclockwise
Frame: 48
Enclosure: Open

Draft inducer blower assembly. 60 Hz 1.75 Amps, 3000 RPM.The draft inducer blower draws air into the burner and exhausts it out the flue. If the draft inducer motor is defective, the furnace may not heat.

Gas valve kit

Pressure switch

3/4HP 115Volts 60Hz 11 amp 1060 RPM's 3 Speed Open Enclosure 48Y Frame Single Phase CCW 3.5" Shaft

Limit switch,160 open,130 close

Transformer, 120 volt primary 24 volt secondary 40 va

Limit switch, 370 open, manual re-set

Blower housing

Housing blower 10-8

Limit Switch