Shop replacement repair parts for York Furnace model PM9B12N080UP11

Furnace hot surface igniter kit. The igniter gets very hot and glows bright orange to light the gas burner. If the igniter is cracked or defective, the furnace won’t heat.

Run capacitor, single,10mfd,370 volts, oval

Furnace flame sensor. The flame sensor monitors the burner to detect whether or not a flame is present. If the flame sensor is defective, the furnace may not heat.

Genteq Run Capacitor 370 Volt Oval Single 7.5 MFD

Furnace blower motor. This single-phase motor has the following specifications:
Horsepower: 1/2
Voltage: 115
Full-Load Amperage: 7.7
Hertz: 60
RPM: 1175
Speeds: 4
Rotation: Counterclockwise
Frame: 48
Enclosure: Open

Transformer, 120 volt primary 24 volt secondary 40 va

Furnace blower assembly with limit and gasket.
To prevent carbon monoxide from leaking into your home, we recommend replacing the draft inducer gasket when servicing the motor or inducer fan. If you do not have a gasket, you can use high-temperature silicone sealant to seal the furnace.

Limit switch, opens at 200F, closes at 170F

Limit Switch

Switch,pres,air,0.60 iwc on fall,spno

Furnace control board upgrade kit. The control board regulates the supply of power to the furnace components. Be sure to check more commonly defective parts before replacing the control board.

Housing,blower

Flame rollout limit switch. 200'F open, manual close