Samsung Dryer DV330AEB/XAA-02 Parts

Dryer Heating element. If the dryer does not heat check for a blown thermal fuse or thermal cut out. Heating elements will often have a break in the coil element if defective.

Dryer drum roller assembly. Includes the roller shaft and mounting clips. As the bearing in the roller wears, it self-lubricates so no grease is needed. If the dryer is noisy then one or more of the rollers may be worn. The rollers should be replaced in sets either both front or both rear.

Dryer drum drive belt. This slender belt wraps all the way around the dryer drum, around a tension pulley, and then around the drive motor pulley. If the drum will not turn when the dryer is turned on the belt is likely broken.

Idler pulley and bracket for dryer drum belt

Dryer thermal fuse (also called the thermal limit). Located on the blower housing. The thermal fuse blows to cut off power to the dryer if the dryer overheats. If the thermal fuse has blown, the dryer won't start. The thermal fuse cannot be reset--if the fuse has blown, it must be replaced.

Thermal fuse with bracket, located on the element housing. The fuse is not resettable and will need to be replaced if blown. If the dryer does not heat, the thermal fuse may be blown.

Dryer thermal fuse on heater housing (non-resettable). The original thermo-protector is riveted to the mounting bracket. You will need to drill out the rivets and replace the new high limit with self-tapping screws. Item # 2074129 comes with the fuse limit already attached to the bracket.

Samsung dryer blower Wheel

Dryer drum drive motor. If the dryer does not start, look for a defective door switch or thermal fuse. Also, if the motor cannot be turned by hand it has failed and will need to be replaced.

Retainer

Dryer drum wrapper assembly

Dryer door catch

Door lever

Motor mounting bracket

Assy button