Samsung Dryer DVE45N5300V/A3-00 Parts

Dryer Heating element. If the dryer does not heat check for a blown thermal fuse or thermal cut out. Heating elements will often have a break in the coil element if defective.

Dryer drum drive belt. This slender belt wraps all the way around the dryer drum, around a tension pulley, and then around the drive motor pulley. If the drum will not turn when the dryer is turned on the belt is likely broken.

Idler pulley and bracket for dryer drum belt

Dryer thermal fuse (also called the thermal limit). Located on the blower housing. The thermal fuse blows to cut off power to the dryer if the dryer overheats. If the thermal fuse has blown, the dryer won't start. The thermal fuse cannot be reset--if the fuse has blown, it must be replaced.

Dryer heating element assembly. If the dryer no longer heats then the heating element may have failed, but it is not the most common cause. The most common cause for a dryer to stop heating is a blown thermal fuse.

Dryer drum drive motor & blower housing assembly

Dryer moisture sensor. The moisture sensor monitors the clothing’s moisture level and sends a signal to the control board when the clothes are dry. If your dryer turns off too early or continues running for a while after the clothes are dry, the moisture sensor might be damaged.

Dryer thermal fuse on heater housing (non-resettable). The original thermo-protector is riveted to the mounting bracket. You will need to drill out the rivets and replace the new high limit with self-tapping screws. Item # 2074129 comes with the fuse limit already attached to the bracket.

Door switch

Samsung dryer blower Wheel

Filter case

Screw-hex

Tapping screw

Motor mounting bracket

Filter Cover