Shop replacement repair parts for Speed Queen Dryer model AG4119

Dryer gas burner valve solenoid set. If the dryer does not heat or heats intermittently the coils could be defective. To test, watch the burner and if the igniter glows for a while and then shuts off without the gas igniting, it usually means one of these coils is bad.

Idler pulley wheel and bearing assembly. The idler pulley puts tension on the drive belt. If the idler pulley fails to put the proper amount of tension on the belt, the dryer will not spin.

Three terminal door switch kit. Be aware that this switch replaces older 2 terminal switches.

This is a Genuine Replacement Part ,The Model Number and Name for the Following Item: Whirlpool (WHIRA) 58804A Gas Valve Solenoid.

Door catch kit, includes catch and clip (metal) Replace both parts for best results

Igniter and bracket assembly

Snap Retaining Ring

Thrust washer

Three terminal door switch

Front panel spring clip fastener

Door catch

Idler pulley spring

Flame sensor

Gas line. 4' stainless gas dryer connector, (1) 3/8" and (1) 1/2" fitting, (1) extra 3/4" fitting, pipe thread sealant, leak test solution, and installation instructions.

Drum front or rear felt seal