Whirlpool Washer/Dryer Combo WGT4027HW2 Parts

Dryer thermal fuse. Opens at approximately 196°F (91°C). *If open check for air flow issues like plugged exhaust vent or damaged blower wheel

Dryer drum support roller. If the dryer is making a rumbling or knocking noise the rollers may be worn out causing the drum not to turn smoothly.

Drive Clutch (Splutch) Kit. This kit has 6 parts; a spring, housing, cam ring, basket drive gear, pulley, and nut. The pulley is driven by the belt and the splutch works with the mode shift actuator to drive the washplate and spin the inner basket. A worn splutch can cause spin or washplate problems

Dryer gas burner valve solenoid set. If the dryer does not heat or heats intermittently the coils could be defective. To test, watch the burner and if the igniter glows for a while and then shuts off without the gas igniting, it usually means one of these coils is bad.

Dryer idler pulley wheel kit. The idler pulley puts tension on the drive belt. If the idler pulley fails to put the proper amount of tension on the belt, the dryer will not spin

Drive belt

The Whirlpool Blower Wheel WP697772 is a high-quality replacement part that attaches to the drive motor shaft and blows air through the drum and out through the exhaust vent. It is important to use safety equipment and disconnect the appliance before any service or repair.

White washer lid strike assembly. The strike is what the lid lock hooks onto to lock the washing machine lid. If old strike looks different the latch may need to be replaced as well.

Drum hole plug

Screw, bracket mounting 8-32 x 1/2

Clip, thermostat

Duct locator clip

Spacer-toe panel

Bracket, hinge