Montgomery Wards Dryer LNC7640A-80/REVA Parts

Dryer drum drive belt. This belt is approximately 1/4" wide x 92-1/4" long. It is flat on one side and has 4 ribs and 3 grooves on the other. It replaces many other belts, including some with 5 ribs and 4 grooves. The belt attaches to the motor pulley and spins the drum as the motor rotates

Dryer thermal fuse and high limit thermostat kit for both gas and electric models. If the dryer does not heat then the thermal fuse may have blown and will need to be replaced.

Dryer lint filter (lint trap). Your lint filter should be replaced if it is torn or damaged in any way.

Door catch kit, includes catch and clip (metal) Replace both parts for best results

Heating element assembly with replacement high limit thermostat, L248-80 (240 Volt, 4750 Watt). Dryer Heating element. If the dryer does not heat check for a blown thermal fuse or thermal cut out. Heating elements will often have a break in the coil element if defective.

Cycling thermostat, L146-25, 2 wire with extra terminal

Glide for main drum front support, left side

Glide for main drum front support, right side

Pushbutton

Idler arm & wheel assembly

Tumbler glide pad with adhesive backing

Knob And Skirt Assembly

Dryer drum support roller kit with axles and mounting screws. The kit has been updated; it has 1 plastic spacer that is the same thickness of 2 old spacers.

Motor with attached pulley

Blower wheel, 3-1/8” deep, 7-1/2” fin diameter, 6-3/4” hub diameter, 20 standard fins, ½” diameter motor shaft, 7/16” motor shaft diameter to flat side of shaft. Most common.