Shop replacement repair parts for Montgomery Wards Dryer model LNC8744A-80

Dryer drum drive belt. This belt is approximately 1/4" wide x 92-1/4" long. It is flat on one side and has 4 ribs and 3 grooves on the other. It replaces many other belts, including some with 5 ribs and 4 grooves. The belt attaches to the motor pulley and spins the drum as the motor rotates

Dryer gas valve solenoid coil kit. The kit includes both 2 and 3 wire coils. If the dryer does not heat or heats intermittently the gas valve coils may be defective.

Dryer thermal fuse and high limit thermostat kit for both gas and electric models. If the dryer does not heat then the thermal fuse may have blown and will need to be replaced.

Door catch kit, includes catch and clip (metal) Replace both parts for best results

Dryer drum drive motor assembly. If the dryer does not start the motor could be bad. Before replacing the motor the door switch and thermal fuse should be tested to determine if they are defective.

Drum glide kit, right side. *Pad has adhesive backing

Door Seal - Dryer.

Front glide kit, (1) right (1) left glide (2) pads with adhesive backing. Instructions included.

The Whirlpool Burner Igniter WP31001556 is a high-quality replacement part for dryers that lights the gas burner to heat the dryer during the cycle. It replaces several other part numbers. Disconnect the appliance from all utilities prior to installation.

Belt idler rod and wheel assembly

Gas valve conversion kit, Natural to LP (liquid propane) gas.

Dryer timer.NOTE: This part is often misdiagnosed and requires electrical testing with a volt/ohm meter to determine if it is defective. *Please call with model and serial number to verify correct part.

Cycling thermostat, L146-25, 2 wire with extra terminal

Conversion kit, LP to Natural gas

Spring, idler