Shop replacement repair parts for Montgomery Wards Dryer model LNC7216A/REV.D

Dryer drum drive belt. This belt is approximately 1/4" wide x 92-1/4" long. It is flat on one side and has 4 ribs and 3 grooves on the other. It replaces many other belts, including some with 5 ribs and 4 grooves. The belt attaches to the motor pulley and spins the drum as the motor rotates

Dryer lint filter (lint trap). Your lint filter should be replaced if it is torn or damaged in any way.

Door catch kit, includes catch and clip (metal) Replace both parts for best results

Heating element assembly with replacement high limit thermostat, L248-80 (240 Volt, 4750 Watt). Dryer Heating element. If the dryer does not heat check for a blown thermal fuse or thermal cut out. Heating elements will often have a break in the coil element if defective.

Drum glide kit, right side. *Pad has adhesive backing

High limit thermostat, L248-80F

Front glide kit, (1) right (1) left glide (2) pads with adhesive backing. Instructions included.

Cycling thermostat, L146-25, 2 wire with extra terminal

Selector knob

Idler arm & wheel assembly

Heat select switch

Dryer drum roller

Motor with attached pulley

Blower wheel, 3-1/8” deep, 7-1/2” fin diameter, 6-3/4” hub diameter, 20 standard fins, ½” diameter motor shaft, 7/16” motor shaft diameter to flat side of shaft. Most common.

Terminal block for main power cord